Viking Wine Cooler Audible Alarm Sounding Six Times Every Minute and LED Light Flashing Red

Your Viking wine cooler’s audible alarm and flashing red LED light indicate a high or low temperature condition within the unit, potentially jeopardizing your wine’s storage environment. This guide will explain the alarm system, offer troubleshooting steps, and guide you towards resolving the temperature issue.

The Alarm System Explained

The alarm system serves as a crucial warning mechanism, alerting you when the temperature inside your wine cooler deviates significantly from the set point. This ensures prompt action to prevent damage to your valuable wine collection.

Troubleshooting the Alarm

1. Silence the Alarm: Press and hold the “ON/OFF” button for approximately one second to silence the audible alarm and clear the visual alert on the display. However, remember, silencing the alarm doesn’t address the underlying temperature issue.

2. Verify Temperature Readings: Once the alarm is silenced, check the current temperature displayed on the control panel. Compare it to the set temperature you have programmed. A significant discrepancy indicates a potential problem with the cooling system or its ability to maintain the desired temperature.

3. Door Check: Ensure the wine cooler door is properly closed and sealed. A slightly ajar door can disrupt the internal temperature, triggering the alarm.

4. Review Recent Changes: Have you recently added or removed a significant number of bottles? Overloading the wine cooler can strain the cooling system and affect temperature regulation. Conversely, a sparsely filled unit can also lead to temperature fluctuations.

5. Power Supply Check: Verify that the wine cooler is plugged into a functioning outlet and receiving power. A power surge or outage could temporarily disrupt the cooling system, triggering the alarm.

Addressing the Temperature Issue

Depending on the cause identified in the troubleshooting steps, you can take the following actions:

• Adjust Set Temperature: If the displayed temperature is significantly higher than the set point, try lowering the set temperature by a few degrees. Conversely, if it’s much colder, raise the set temperature slightly. Allow sufficient time for the cooler to adjust and monitor the temperature readings.

• Reduce or Rearrange Bottles: If the cooler is overloaded, remove some bottles to improve air circulation and reduce strain on the cooling system. Conversely, if there are very few bottles, consider strategically placing them to promote even temperature distribution.

• Contact a Professional: If the troubleshooting steps don’t resolve the issue, or you suspect a malfunction with the cooling system itself, contact a qualified Viking appliance repair technician. They can diagnose the problem and perform necessary repairs to ensure optimal performance and prevent further temperature fluctuations.

Remember:

• While silencing the alarm provides temporary relief, it’s crucial to address the underlying cause of the high or low temperature to avoid potential damage to your wine.

• If you’re unsure about any troubleshooting step or suspect a more complex issue, seeking professional assistance is always recommended.

By following these steps and understanding your Viking wine cooler’s alarm system, you can maintain proper temperature control and safeguard your prized wine collection.